My apricorn sata wire 3.0 is not working

MY APRICORN SATA WIRE 3.0 IS NOT WORKING FOR MAC
MY APRICORN SATA WIRE 3.0 IS NOT WORKING UPGRADE

Selecting the Destination Drive Drive Verification Once you have selected your Source Drive, EZ Gig will ask you to select your Destination Drive. NOTE: Your computerвЂ™s internal drive will usually be denoted by the prefix AHCI or IDE. EZ Gig will then scan for connected drives. This is the drive you would like to copy from and in most cases is the internal drive in your notebook. Once EZ Gig has scanned for connected drives, you will be asked to select your Source Drive. Click the вЂњLetвЂ™s Get StartedвЂќ button to proceed. Creating a Bootable EZ Gig CD If you downloaded EZ Gig from ApricornвЂ™s website, you have the option of creating a bootable EZ Gig CD or thumb drive to use in the future.Д¬loning your hard drive with EZ Gig Selecting the Source Drive 1.

MY APRICORN SATA WIRE 3.0 IS NOT WORKING UPGRADE

Although the steps below are not absolutely necessary to run EZ Gig, itвЂ™s best to try and clean-up disk errors BEFORE they are copied over to the new drive.Д¬onnecting Your Hard Drive Before starting the EZ Gig software, please ensure that your new hard drive is connected to your notebookвЂ™s USB port via one of ApricornвЂ™s Upgrade products listed on the previous page. Most file system errors are not immediately obvious to the user, but can be identified and repaired with a few simple steps. Simply connect your 2.Д«efore Running the Software EZ Gig instructions for Windows 7 & Vista After many years of use, hard drives can become cluttered with unusable file fragments and other file-system errors. The Package Contains Installing your SATA Wire is easy. With the help of ApricornвЂ™s user-friendly cloning software, you can clone or backup your notebook drive in a snap. Use it to connect any 2.5вЂќ SATA notebook hard drive to your computer. Getting to know your SATA Wire Connecting your SATA Wire Introduction Device Installation The SATA Wire is perfect for transferring data to bare drives.

MY APRICORN SATA WIRE 3.0 IS NOT WORKING FOR MAC

TABLE OF CONTENTS Getting to know your SATA Wire HotCopy / LiveImage Avoid exclusive read access 20 20 4 4 4 4 Partitions 21 22 5 5 Start Clone Before running EZ Gig we recommend EZ Gig instructions for Windows 7 & Vista Changing the default вЂњPower OptionsвЂќ 6 6 7 7 23 24 24 24 Congratulations your Clone is Complete 25 Connecting Your Hard Drive 8 SuperDuper! Backup Software for Mac 26 After the Clone 27 27 28 SATA Wire FAQs 29 EZ Gig FAQs 32 Contacting Tec

SATA Wire 3.0 USB 3.0 to 2.5вЂќSATA CONNECTOR UserвЂ™s Guide Attention: If your SATA Wire shipped with a previous version of EZ Gig III, you can download the new EZ Gig IV from ApricornвЂ™s website at: Review the most current SATA Wire FAQвЂ™s at.

My apricorn sata wire 3.0 is not working